Single Mast Nautical Flagpole
The Single Mast aluminum
flagpoles provide the ability to fly the national flag
with additional flags, pennants, or burgees. The topmost
bracket, and the gaff and yardarm brackets, are
fabricated from 6063-T6 aluminum tubing and plate,
heliarc welded, and are finished to match the flagpole
shaft. The resulting structure is one of beauty,
strength, and authenticity, and is particularly
appropriate in a nautical setting.
Concord flagpoles are made from all new, seamless 6063-T6
aluminum tubing, having a uniform conical taper of approximately
1" in every 5'- 6". Lowermasts up to 38'- 6" in length can be
fabricated in one piece and shipped via motor freight to almost
any destination. Lengths requiring shipment in sections shall
be factory fitted with a self-aligning internal sleeve
which will facilitate field assembly without welding. Yardarm is attached to the lowermast with
fabricated aluminum fittings. Finish is the same as on the
DEEP LUSTER FINISH
All Concord flagpoles shall be highly polished with fine
grain aluminum oxide cloths, resulting in a high quality deep
luster finish. This new deep luster finish represents the
ultimate in architectural finishes for aluminum flagpoles. The
elegant soft sheen remains maintenance free. Each shaft shall be
tire wrapped in protective paper, and shipped in a hard fiber
tube to protect the finish. The unexposed portion of the shaft
which will be below grade, shall be given a heavy coat of
Fittings listed below are standard with all single-mast nautical flagpoles ground set:
Constructed of #14 Ga. aluminum, with a flush seam and gold anodized finish.
Cast aluminum, the standard truck shall be a single
halyard, revolving, non-fouling type, complete with 26 stainless
steel ball bearings and one 2 3/8" diameter cast nylon sheave.
Three sets of #10 (5/16") white waterproof
polypropylene, each equipped with two chrome swivel snaps to
secure the flag. (Other types of halyard material available.)
Three 9" cast aluminum cleats with deep luster finish to match
the shaft. Tamperproof stainless steel socket head bolts
The ornamental base or flash collar, shall be spun aluminum,
Type FC-11. The diameter of the collar shall be at least 1 "
larger than the diameter of the foundation sleeve. The finish
shall be deep luster.
Fabricated from #16 ga. galvanized steel, with a steel base
plate whose square dimension is at least the internal diameter
of the sleeve plus 4". A setting plate 6" square shall be
provided. The setting plate shall be securely welded to the
ground spike at least 6" below the base plate. The ground spike
shall be 3'4" diameter, not less than 18" long.
Other finishes are available, please contact us for pricing.